Blind Nailing Hardwood Floor

We used and recommend the duofast 15 gauge hardwood flooring stapler for this job.

Blind nailing hardwood floor.

Blind nailing is setting a nail into the hardwood flooring board at a 45 degree angle just above the tongue of the board and driven down into the joist or subfloor surface. Flooring nailers which both force boards tightly together and drive a fastener called a cleat are often used in blind nailing applications. The process of blind nailing. Solid hardwood flooring only can be installed on or above ground level with a plywood subfloor.

The humble nail has a long history of craftsmanship behind every bag or box. Be sure to countersink the nail drive it slightly below the surface of the wood to prevent interference in the. Flooring nails have special qualities that make them suitable for the job. Engineered flooring can be installed above grade at grade and below grade level do not install hardwood flooring in bathrooms.

For tongue and groove flooring drive a nail at a 45 degree angle through the tongue then conceal it by engaging the groove of the next board. Always check with the manufacturer s instructions to determine if your hardwood floor can be installed over an in floor radiant heat system. When using a flooring nailer the nose of the tool is set down on the top inside corner of the board s tongue while the nail is driven at an angle through the flooring material and into the subfloor. In olden times blind nailing was done with a hammer to start the nail then as a woodworker got close to the wood a nailset was used with the hammer to countersink the.

Built for durability our nailers will withstand the wear and tear of any jobsite and feature bumpers to protect pre finished floors against marring. Before flooring installers had power nailers they had to blind nail all flooring boards by hand. The process involves driving a series of nails into the tongue of a. If you re using 2 25 traditional boards you ll likely still have to blind nail as a hardwood flooring nailer will not fit yet.

If you are installing 3 25 boards or larger the third row can be installed with a flooring nailer stapler.