Push the power door unlock button once to turn on the auto lock feature.
02 explorer no door lock.
Press the unlock control then press the lock control.
The 2002 ford explorer has 7 problems reported for power door lock not working.
Press the power door unlock control three times.
My 02 ford explorer power door locks just up and quit all at the same time.
Two beeps one short and one long signals that the auto locks have been enabled so if you receive two beeps start the process over again.
On the 2011 2018 ford explorer the passenger fuse panel is located under the instrument panel to the left of the steering column.
Average failure mileage is 95 400 miles.
One beep confirms the auto locks have been disabled.
2002 ford explorer door ajar problem fixed.
The horn will chirp.
The first thing to get keyless entry door factory code you need to locate the passenger fuse panel.
Since then when it is hot i get a door open warning light.
Press the power door lock button once and listen for the horn to beep one time.
I have a 2002 ford explorer xls that was purchased new.
The common problem is that the switch is not closed this will cause your dome lite to be on door ajar light on and will malfunction any aftermarket auto alarm.
Turn the ignition to off.
No door is opened but the doors refuse to lock and the warning light stays on.
They wont work with the fob or the combination pad outside the door either i need to know where the door lock relays are located and would love to have a door lock wiring diagram i already removed the drivers door panel and the rubber wire duct in the door jamb and found a red wire broken and tada.
Approximately 1 year after purchase started developing a crack on the panel beneath the rear window.
Older versions used a plunger that you could easily test with with your fingers.
Re upload from my old channel.